For sale is a 10 hp continuous duty, 3 phase 220 volt, 24.2 amp, 1740 rpm electric motor by General Electric. I bought this for a project, and I was told it was single phase. When I got home I quickly realized it's 3 phase. I do not have 3 phase power available, so it's no good to me. It spins freely by hand, but I can not verify if it actually works. It has a 9 3/4 inch double groove pulley on it. If you don't want the pulley on it, I can pull it off. It has a 1 3/8 output shaft, and the motor is approximately 24 inches long total and the body is about 14 inches in diameter. I paid $75 for it. I would like to just get my money back, so I'm asking $75. I might consider a trade for a 3 to 5 hp single phase electric motor. Message if you have any questions.