It’s off-season project time!

Are you tired of firing up your pivots and most of your smaller nozzles on your inner spans getting stopped up right off the bat?

Your pump starts up and any sand or pipe scale that is in your pipe comes up first. While it is pressuring up it, it naturally gets pushed into the first drops it comes to. The inner nozzles are the smallest as they move around the center point the slowest, so they plug easier. We have a solution.

Our poly drop/outlet filters are just $4.90 each-available in Coarse or Fine mesh.

You un-thread your gooseneck, thread our filter into your pivot pipe, then thread your gooseneck onto the threaded filter.

The filters grab the sand/pipescale/sediment, keeping it out of your nozzles, and as the pivot pressures up, the water pressure pushes any sediment out to the end of the pivot end flush/trap-and away from your nozzles.

Open nozzles= no skips.

We also carry pivot end flushes also!

Come grab them at Direct Pivot Parts TX in Hart,TX or I can ship them to your door.

806-414-5166 or 308-391-1214