I’ve got an older Dillion RL450 turret press with 45acp dies. This comes with everything you need to start reloading 45acp and load around 100rds right out of the gate. Included is a tumbler, digital scale, bullet puller, lots of primers close to 500, 8lb keg of powder unopened, 1lb of powder unopened, and two 1lb that are about half full, also roughly 100 projectiles and prob over 500 clean brass.  The clamp that holds the powder mesure onto the powder die is broken I got it this way and have loaded over 1000rds like it is. I’m sure I’m leaving out some odds and ends but this is a perfect set up to start reloading or get back into it. I just don’t shoot as much as I did and haven’t used it in 3 years.  if you have any questions please call I normally don’t answer unknown numbers so please leave a voicemail.